BUSHING & SLEEVES KIT A-ARMS REAR POLARIS GENERAL 1000 (2019- )

JAY PARTS BUSHING & SLEEVES KIT A-ARMS REAR POLARIS GENERAL 1000 (2019- )

hardened stainless steel sleeves

hardened stainless steel seal cups

PE-GL bushings with oil additive

sealed with O-rings

Made in Europe

One kit is for both sides on the rear on the frame side (left and right).


JAY PARTS BUSHING & SLEEVES KIT A-ARMS REAR POLARIS GENERAL 1000 (2019- )

The sleeves and seal cups are made of hardened stainless steel, only the best is good enough for our claim!

PE-GL with oil additive was used for the bushings as a wear-resistant material. The O-ring in the stainless steel sealing cap seals against dirt and water.

FEATURES

- Made in Europe

- hardened stainless steel sleeves

- hardened stainless steel seal cups with O-ring

- PE-GL bushings with oil additive

DELIVERY PER KIT

4 sleeves long

2 sleeves short

12 bushings

12 seal cups (pre-assembled with O-rings)

One kit is for both sides for the rear on the frame side (left and right).

WORKS WITH THE FOLLOWING MODELS

Polaris General 1000 2019 -

ATTENTION ON ASSEMBLY

Don't hit the bushings with a hammer!

Apply a little grease to the screw to avoid corrosion. Grease the O-ring and use the grease on the inside of the bushing extensively.

220,10 €
Please select variants first