AY PARTS BUSHING & SLEEVES KIT REAR WHEEL SIDE POLARIS GENERAL 1000 (2019- )
hardened stainless steel sleeves
hardened stainless steel seal cups
PE-GL bushings with oil additive
sealed with O-rings
Made in Europe
JAY PARTS BUSHING & SLEEVES REAR WHEEL SIDE FRONT POLARIS GENERAL 1000 (2019- )
The sleeves and seal cups are made of hardened stainless steel, only the best is good enough for our claim!
PE-GL with oil additive was used for the bushings as a wear-resistant material. The O-ring in the stainless steel sealing cap seals against dirt and water.
- Made in Europe
- hardened stainless steel sleeves
- hardened stainless steel seal cups with O-ring
- PE-GL bushings with oil additive
DELIVERY PER KIT
4 seal cups (pre-assembled with O-rings)
For one vehicle you need 2 kits!
WORKS WITH THE FOLLOWING MODELS
Polaris General 1000 2019 -
ATTENTION ON ASSEMBLY
Don't hit the bushings with a hammer!
Apply a little grease to the screw to avoid corrosion. Grease the O-ring and use the grease on the inside of the bushing extensively.